FREE SHIPPING
Free Shipping available for orders over £49 (excludes some postcodes, large fragile items & Livestock)
Seachem Phosbond 1L
PhosBond is a revolutionary new product that combines the phosphate removing capabilities of both aluminium oxide and granular ferric oxide into a singular material forming a synergistic effect. It rapidly removes phosphates and silicates from saltwater and freshwater, combining the best of both types of phosphate removers.
Its high porosity and surface area give it a large binding capacity, while its physical strength and integrity assures that it will not break down from mechanical stress.
Seachem Phosphate Remover's Compared
Product
PO4 bound
PhosGuard (Alumina Oxide)
0.87 mg/g
PhosBond (GFO and Alumina Oxide hybrid)
1.19 mg/g
PhosNet (GFO)
1.41 mg/g
Directions:
For best results, PhosBond should be rinsed before use and placed so as to maximize the flow of water through it but not so that it tumbles against itself in flow. It may be used in a canister filter, media chamber, box filter, or any high flow area of a trickle filter. Use of a filter bag such as 'The Bag' is recommended.
Use 60 mL (1/4 cup) for every 200 L (50 US gallons) saltwater or 400 L (100 US gallons) freshwater. Leave product in place for 4 days, then test phosphate or silicate concentrations. If the concentration of the component you are trying to decrease has not dropped to around 0.02 mg/L, then replace the PhosBond, otherwise leave in place until levels begin to climb again. As long as concentrations remain under control, the product is not exhausted. Over treating is not recommended. PhosBond is not an exchange resin and does not release anything into the water. It does not leach phosphate or silicate back into the water and may be removed, dried, and returned to service until exhausted. Continuous use of small quantities is better than intermittent use of larger quantities.
Product Code | 770073 |
---|---|
Barcode | 116126502 |
Brand | Seachem |
Drop Ship | No |